Alpha Microsystems AM-649 Manuál s instrukcemi stáhnout pdf (Strana 11)

Page 8 Installation Instructions: AM-65X 1/4" Streaming Tape Drive

PDI-00651-00, Rev. A01

The AM-65X has a number of mounting screw holes on its side. There are corresponding holes

in the plastic mounting base. Align the screw holes on the drive with the designated holes in the

mounting base (marked as A in Figure 4). Make sure the drive's front panel is pointed in the

direction indicated by the large arrow.

Install the two screws (included in the mounting kit) that hold the plastic mounting base to the

drive. If you are installing a diskette drive or another tape drive along with your AM-65X, mount

this drive next to the AM-65X, as shown in Figure 3.

DWF-20218-00

MAKE SURE THE DRIVE'S

FRONT PANEL IS POINTED IN THE

DIRECTION INDICATED BY THE ARROW

SCSI DAT OR STREAMING TAPE DRIVE, or

ANY 5-1/4" HALF-HEIGHT SCSI HARD DISK DRIVE

AM-645 FULL-HEIGHT 8MM MAGNETIC TAPE DRIVE, or

ANY 5-1/4" FULL-HEIGHT SCSI HARD DISK DRIVE

ANY 5-1/4" HALF-HEIGHT FLOPPY DISKETTE DRIVE, or

ANY 5-1/4" HALF-HEIGHT SCSI HARD DISK DRIVE

Figure 4 - Plastic Mounting Base

Set the drive assembly into its mounting position inside the chassis.

Set the metal support bracket on top of the drive assembly as shown in Figure 3. Position the

bracket so the mounting hole shown in Figure 5 aligns with the screw hole on the side of the

AM-65X, and the screw hole to attach the drive assembly to the front bezel aligns with the screw

hole in the front bezel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Žádné komentáře

Alpha Microsystems AM-649 Manuál s instrukcemi Strana 11