Alpha Microsystems Eagle 100 Instalační příručka stáhnout pdf (Strana 15)

Building a Simple Network Page 2-9

AlphaNET Installation Guide, Revision 05

connection process. The number specification following the ETHZON statement will always be assigned

the same number as used in the first element of the TRMDEF statement.

TDVDEF AM62A,AM62,AM72,AM75

TDVDEF is only supported on AMOS 2.1 or later releases; it is not supported in AMOS 1.X

releases.

The TDVDEF statement loads the specified terminal drivers for use by virtual terminal connections.

Without the TDVDEF statement, the only terminals supported as virtual terminal connections would be

those defined in the normal TRMDEF statements. The TDVDEF statement can also be used to load all of

the terminal drivers in the DVR: account, for example:

TDVDEF *

MSGINI 40K

AMOS’s Inter Task Communication System, the foundation for all of AlphaNET, requires buffer space

within the system communication area. This space is allocated by the MSGINI command. This command

must be performed before the first SYSTEM command, and takes as an argument the amount of memory

to allocate. A minimum of 16K should be allocated when using AlphaNET.

ERSATZ ETH101.ERZ

The ERSATZ command is followed by the name of the network ersatz file we defined earlier. This

command initializes the network ersatz table and loads it into AMOS. Make sure the network ERSATZ

command is inserted into the initialization command file before the first SYSTEM command.

NETINI ETH101.NIN

The NETINI command is followed by the name of the network initialization file. This command

initializes your network device driver using the information in the network initialization file.

SYSTEM RPC.SYS/N

The remote procedure call facility requires you to allocate and initialize a support module, RPC.SYS,

within system memory. To do so, add the command SYSTEM RPC.SYS/N to the other SYSTEM

commands within the system initialization command file.

SMEM 1M

The SMEM statement sets up a pool of sharable memory for virtual terminal connections. If you use the

SMEM statement, use the /S switch when you initialize VTSER later.

SETJOB NETSER,NETSER,100K,NETSER.JIN

This statement attaches the NETSER job to the NETSER terminal definition, allocates memory for it,

and processes the NETSER job initialization file (NETSER.JIN). The minimum memory allocation for

the NETSER job is 100K.

WAIT NETSER

The WAIT NETSER command that appears directly below the NETSER SETJOB statement insures

NETSER is up and running before going on to the next statement in the system initialization command

file.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Žádné komentáře

Alpha Microsystems Eagle 100 Instalační příručka Strana 15