Alpha Microsystems Eagle 100 Instalační příručka stáhnout pdf (Strana 16)

Page 2-10 Chapter Two

AlphaNET Installation Guide, Revision 05

SETJOB VTSER,VTSER,32K,VTSER.JIN

Virtual terminal connections afford remote users essentially the same user privileges as local users.

If you choose to support virtual terminal connections, make sure you read the section dealing with

network security in Chapter 3.

This statement attaches the VTSER job, allocates memory for the job, and processes the VTSER job

initialization file (VTSER.JIN). The minimum memory allocation for the VTSER job is 200K unless you

are using SMEM, in which case it is 32K. If you are not using SMEM, you will need to supply the

VTSER job with enough memory to support the maximum number of virtual terminal connections you

would expect to support at any one time. (See Chapter 3 for more details.)

SET LINK DAVE:

The SET LINK command turns on the network and allows your computer to both send and receive data

over the network. You can specify the network ersatz name (as shown in the example) or you can use the

cpuID number. SET LINK can only be executed from the OPR: account. In our example, we included the

SET LINK command in the system initialization command file and you'll notice that just before the SET

LINK command there is a command logging the boot job into OPR: The SET LINK command can also

be entered from AMOS command level after the computer boots. To remove the computer from the

network, use the SET NOLINK command:

SET NOLINK DAVE:

RETURN

8. Create a NETSER.JIN File

In addition to adding the SETJOB statement for the NETSER job in the system initialization command

file, you must create a NETSER.JIN file in your SYS: account. The file will look like this:

LOG SYSTEM SERVICE

NETSER

9. Create a VTSER.JIN File

In addition to adding the SETJOB statement for the VTSER job in the system initialization command

file, you must create a VTSER.JIN file in the account specified in the SETJOB statement. If you do not

specify a logical device and account number, the default is DSK0:[1,4]. The file will look like this:

LOG SYSTEM SERVICE

VTSER/S {password}

The password following the VTSER command is optional and is limited to 10 characters or less. See the

section “VTSER and Network Security” in Chapter 3 for more information on the VTSER password. The

/S switch tells VTSER to use the sharable memory defined by the SMEM statement. See Chapter 3 for

details.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Žádné komentáře

Alpha Microsystems Eagle 100 Instalační příručka Strana 16