Alpha Microsystems Eagle 100 Specifikace Strana 32

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 89
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 31
CHAPTER 3
AM-3000M/LC Hardware Installation
3.1HARD DRIVE CONSIDERATIONS
Whether you’re installing a new pre-configured Roadrunner bootable SCSI disk drive, or
you’re going to use your existing hard drive as the main system boot drive, there are
certain considerations that must be taken into account before proceeding with the actual
hardware upgrade.
The following sub-sections highlight the various differences between a
standard
(not
AM-540 modified) AM-140 CPU board, and a
modified
(with AM-540) AM-140 CPU
board. You should read and understand the following information before attempting the
Roadrunner hardware upgrade.
Remember - before attempting any software or hardware upgrade, be sure you have a
current backup of your system, and a verified warm-boot tape!
3.1.1Roadrunner Boot PROM Routines
For a
standard
AM-3000M system, the boot PROM on the Roadrunner is programmed
to look first at the SASI port on the main CPU board. If a SCSI drive addressed as I.D.0
is detected on the SASI port it will be selected as the boot device. If no boot drive is
detected on the SASI port, the boot PROM will then check the Roadrunner’s SCSI port
for a device. If a SCSI drive addressed as I.D.0 is detected, then it will be selected as
the boot device.
For an
AM-540 modified
AM-3000M system, the boot PROM on the Roadrunner is
programmed to bypass the SASI port on the main CPU board since the EN modification
for the AM-540 upgrade effectively eliminates any communication to the SASI port. If
the Roadrunner board does not meet the minimum revision levels as listed in the
"HARDWARE COMPATIBILITY" section of this document, then the system will "hang"
indefinately waiting for a response from the SASI port... that will never come!
If your configuration includes a Tandberg tape drive or other SCSI peripheral, make
sure the bootable hard disk and the peripheral device(s) are attached to the SAME bus.
PDI-00172-60, Rev. A02
Zobrazit stránku 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 88 89

Komentáře k této Příručce

Žádné komentáře