Alpha Microsystems Eagle 100 Specifikace stáhnout pdf (Strana 83)

Page C-6 Appendix C

4.Your computer boots from a monitor called AMOS32.MON. In order for the

Roadrunner to boot, a new monitor must be created by embedding a driver called

SCZRR.DVR, which is compatible with the Roadrunner SCSI port. The boot

monitor used by the Roadrunner is also called AMOS32.MON.

The Roadrunner’s high performance SCSI port supports write buffering for SCSI

hard disk drives. If you are going to use this feature, please read the information in

Appendix B before continuing with this procedure.

Use the MONGEN program to embed the Roadrunner SCSI compatible hard disk

driver into the AMOS monitor located in account [1,4].

For Example:

LOG SYS:

RETURN

MONGEN

RETURN

Input monitor name: AMOS.MON

RETURN

New disk driver: SCZRR.DVR

RETURN

New language definition table name: ENGLSH

RETURN

New monitor name: AMOS32.MON

RETURN

SAVE AMOS32.MON

RETURN

The monitor is now compatible with Roadrunner hardware; the computer will NOT

boot if you press reset before the Roadrunner is installed!

C.4ROADRUNNER INSTALLATION CHECKLIST

At this point in the installation, all of the following preliminary steps required to support

the Roadrunner hardware should be complete:

1.If you’re using an AM-645 Exabyte tape drive or a Tandberg AM-625, AM-626, or

AM-627 tape drive, make sure you read the information on firmware requirements

located earlier in this document.

2.A Roadrunner compatible operating system and corresponding Product Support

Software Kit tape (if applicable) should have been downloaded onto your

computer’s hard disk drive.

Once you have completed all the steps outlined in this appendix, you are ready to install

the Roadrunner hardware.

PDI-00172-60, Rev. A02

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89

Žádné komentáře

Alpha Microsystems Eagle 100 Specifikace Strana 83