Alpha Microsystems Eagle 100 Specifikace Strana 48

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 89
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 47
CHAPTER 4
AM-3000 VME Hardware Installation
4.1HARD DRIVE CONSIDERATIONS
Whether you’re installing a new pre-configured Roadrunner bootable SCSI disk drive, or
you’re going to use your existing hard drive as the main system boot drive, there are
certain considerations that must be taken into account before proceeding with the actual
hardware upgrade.
The following sub-sections highlight the various hard drive configurations and how to
deal with them. You should read and understand the following information before
attempting the Roadrunner hardware upgrade.
Remember - before attempting any software or hardware upgrade, be sure you have a
current backup of your system, and a verified warm-boot tape!
4.1.1Roadrunner Boot PROM Routine
The boot PROM on the Roadrunner is programmed to look first at the SASI port on the
AM-185 or 185-50 board. If a SCSI drive addressed as I.D.0 is detected on the SASI
port, it will be selected as the boot device. If no device is detected on the SASI port,
then the boot PROM will check the Roadrunner’s SCSI port for a boot drive.
4.1.2Attaching Hard Drives to Opposite Bus Ports
On an AM-3000 VME system you may attach a SCSI hard drive to the opposite
SASI/SCSI port and treat it much the same as a sub-system drive. That is, if your
system is booting on the Roadrunner’s SCSI port, you could create a disk driver using
FIXLOG and SCZDVR.DVR to access a SASI/SCSI-1 hard drive on the CPU SASI port.
Or, if you’re booting on the SASI port, you could create a disk driver using FIXLOG and
SCZRR.DVR to access a SCSI-1/SCSI-2 hard drive on the Roadrunner’s SCSI port.
Remember however, that both drives should not
be addressed as I.D.0, as the
Roadrunner’s boot routine will try to boot from the SASI port first if it sees a drive
connected as I.D.0. Also, no peripheral device other than a hard disk drive
can be
accessed, if it’s attached to the opposite bus port.
PDI-00172-60, Rev. A02
Zobrazit stránku 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 88 89

Komentáře k této Příručce

Žádné komentáře