Alpha Microsystems Eagle 100 Specifikace stáhnout pdf (Strana 55)

Page 4-8 AM-3000 VME Hardware Installation

4.2.2Installing the Roadrunner Board

The following instructions apply to the pedestal chassis only. Refer to Appendix E for

rack mount system instructions.

Before you install your Roadrunner, make sure it’s set up properly for your system

configuration. The AM-174 Jumper Configuration illustration explains the function of

each jumper.

Use the following instructions to install the Roadrunner:

1.The Roadrunner board installs on top of the system power supply. If you currently

have a Xebec or AM-528 board installed at this location, it must be removed.

2.The Roadrunner board must be positioned on the power supply as shown in the

following illustration. Ensure the end with the 50-pin and two 34-pin connectors is

located nearest the rear

panel.

3.The board is held in place with four 6-32 phillips-head screws.

TOWARD

REAR PANEL

TOWARD

FRONT PANEL

6-32 PHILLIPS-

HEAD SCREW

Note how the Roadrunner

board is positioned so these

connectors are located

nearest to the rear panel

MC1115

#6 NYLON

WASHER

POWER SUPPLY

Mounting the Roadrunner Board

PDI-00172-60, Rev. A02

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 88 89

Žádné komentáře

Alpha Microsystems Eagle 100 Specifikace Strana 55